High Efficiency Antimicrobial Diffuser Tubing, 100' Roll
Includes antimicrobial component to greatly reduce fouling—safe for fish!
This patented, low-pressure rubber/polyethylene diffuser hose is made for aquaculture. Step on it—it springs right back! This is efficient tubing, with a pressure resistance of only 12" of H2O at normal flowrates when new. Diffuser lengths of up to 20' per inlet are possible at low airflow rates. Tubing has a good oxygen transfer rate and is compatible with both regenerative blowers and linear air pumps.
The gas flowrate is an average of .1–.5 cfm/ft; higher and lower flows are possible. Tubing produces a strong volume of medium-size bubbles (approximately 3 mm). For connections, use 1/2" barb fittings with clamps. Hose ends may be heat-sealed or fitted with a plug and clamp. To counteract buoyancy, hold-downs or weights are required. For best results, the tubing should be oriented with the blue stripe on the bottom. Inside diameter is 1/2" (13 mm); outside diameter is 1" (25 mm). Made in the USA by Colorite Plastics.
No warranty due to individual clogging and fouling possibilities.
Note: Tubing is also known as hose.
Diffusers are also known as airstones.
New! Includes antimicrobial component to greatly reduce fouling—safe for fish!
This patented, low-pressure rubber/polyethylene diffuser hose is made for aquaculture. Step on it—it springs right back! This is efficient tubing, with a pressure resistance of only 12" of H2O at normal flowrates when new. Diffuser lengths of up to 20' per inlet are possible at low airflow rates. Tubing has a good oxygen transfer rate and is compatible with both regenerative blowers and linear air pumps.
The gas flowrate is an average of .1–.5 cfm/ft; higher and lower flows are possible. Tubing produces a strong volume of medium-size bubbles (approximately 3 mm). For connections, use 1/2" barb fittings with clamps. Hose ends may be heat-sealed or fitted with a plug and clamp. To counteract buoyancy, hold-downs or weights are required. For best results, the tubing should be oriented with the blue stripe on the bottom. Inside diameter is 1/2" (13 mm); outside diameter is 1" (25 mm). Made in the USA by Colorite Plastics.
No warranty due to individual clogging and fouling possibilities.
Note: Tubing is also known as hose.